Kippzonen 2AP Sun Tracker Uživatelský manuál stáhnout pdf (Strana 27)

INSTALLATION AND SETUP

4.3 MOUNTING THE 2AP

Proper placement of the unit is important when installing the 2AP, as it requires a specific amount of

space to operate. Refer to section 4.7 for additional information on how to mount and configure the

2AP as a Positioner instead of as a Suntracker.

The 2AP is supplied with a standard ∅ 203 mm bottom flange, which has a 4-hole (∅ 11 mm)

mounting pattern to match that of the optional Height Extension Tube and Tripod Floor Stand with

levelling feet. See section 4.5.1 on how to install the optional Tripod.

The Height Extension Tube is an optional accessory. It extends the height of the 2AP by 60 cm.

Without the Height Extension Tube the 2AP can be mounted directly onto the mounting flange of

the Tripod Floor Stand.

Figure 4.6: Mounting the 2AP on the Height Extension Tube and Tripod Floor Stand.

If it is intended to mount the 2AP on a customer-supplied platform, the bottom flange contains an

extra set of 4 holes, which are threaded, and a set of levelling screws. See figure 4.7 for details of

the bottom flange mounting hole pattern and thread type.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 109 110

Žádné komentáře

Kippzonen 2AP Sun Tracker Uživatelský manuál Strana 27