Kippzonen 2AP Sun Tracker Uživatelský manuál stáhnout pdf (Strana 42)

INSTALLATION AND SETUP

Figure 4.26: Shading Ball Rods Installation

4.5.5 Sun Sensor

The optional Sun Sensor accessory consists of a quadrant sensor fitted within a weather resistant

enclosure with 2AP mounting hard-ware and associated software. A 2AP with Sun Sensor can be

set to three different modes during operation:

1. Suntracking mode:

Normal mode provides operation where the 2AP follows a calculated solar position and logs the

deviation to the measured position. Also the only 2AP suntracking mode if no Sun Sensor is

attached.

2. Active mode:

When the sun is present this mode provides operation where the 2AP follows a measured solar

position and logs the deviation to the calculated position.

3. Correcting Time:

When the sun is present this mode provides operation where the 2AP follows a measured solar

position and logs the deviation to the calculated position. This mode enables the 2AP to correct

for any possible clock drift of the controller board.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 109 110

Žádné komentáře

Kippzonen 2AP Sun Tracker Uživatelský manuál Strana 42